{"id":612,"date":"2020-01-13T03:02:30","date_gmt":"2020-01-13T03:02:30","guid":{"rendered":"https:\/\/www.titanreloading.com\/blog\/?p=612"},"modified":"2022-01-10T06:43:02","modified_gmt":"2022-01-10T12:43:02","slug":"mec-reloaders-troubleshooting-tips","status":"publish","type":"post","link":"https:\/\/www.titanreloading.com\/blog\/mec-reloaders-troubleshooting-tips\/","title":{"rendered":"MEC Reloaders Troubleshooting Tips"},"content":{"rendered":"\r\n

The Mayville Engineering Company (MEC) has been designing, producing, and servicing shotgun shell MEC reloaders that generations of shooting enthusiasts have trusted since 1955. MEC reloaders are proudly made in the USA and available atTitan Reloading, a trusted supplier of premium quality reloading supplies<\/strong><\/a>[<\/a> and equipment. <\/p>\r\n\r\n\r\n\r\n

Reloading ammunition with MEC reloaders is a relatively simple process, though it does involve moving parts on intricate machinery and specific instructions for exact measurements and mixtures. Even the most experienced and avid gun hobbyist can run into problems while operating MEC reloaders. <\/p>\r\n\r\n\r\n\r\n

The following are some helpful tips if you run into trouble while reloading your ammunition <\/p>\r\n\r\n\r\n\r\n

MEC Reloaders Downstroke Issues<\/h2>\r\n\r\n\r\n\r\n

If your reloader is jammed or bottoms out halfway\r\ndown the downstroke, it is most likely due to the drying out of the resizing\r\ncollet. Apply anti-seize lubricant on the outer areas of the collet fingers.\r\nThe issue may also be caused by a buildup of shot or powder inside the collet.\r\nThe wad guide on the progressive reloaders may also be set too low.<\/p>\r\n\r\n\r\n\r\n

Bushing Droppings Varying from Chart Amounts[ <\/h2>\r\n\r\n\r\n\r\n

The bushing chart supplies recommended bushing\r\ninformation, through charges can vary. An accurate, reliable scale is highly\r\nrecommended to ensure accuracy and safety. Always make sure that the charge bar\r\nmoves completely to each side with every motion. <\/p>\r\n\r\n\r\n\r\n

Powder Leakage<\/h2>\r\n\r\n\r\n\r\n

A missing or damage grommet can cause powder to leak\r\nout of the top of the bar. Improperly installed or missing brass washers can\r\nalso lead to powder leakage. Inspect and replace grommets and washers regularly\r\nto ensure a proper seal. <\/p>\r\n\r\n\r\n\r\n

Changing Reloading Lead to Steel Shot<\/h2>\r\n\r\n\r\n\r\n

The process of reloading steel shot requires the\r\ninstallation of a steel shot kit and charge bar. When the kit is installed,\r\nonly the charge bars need to be swapped out to go back and forth to lead shot\r\napplications. <\/p>\r\n\r\n\r\n\r\n

Prominent Features of MEC Reloaders <\/h2>\r\n\r\n\r\n\r\n

Among the design features that come with MEC\r\nreloaders include:<\/p>\r\n\r\n\r\n\r\n