Your Silver Bullet in Reloading Equipment and Supplies!
Save 60-80% off the cost of Factory Ammunition with Titan Reloading

TITAN PRIMER CHUTE

  • TITAN PRIMER CHUTE

TITAN PRIMER CHUTE

  • $12.98


This product has a maximum quantity of 2

TITAN PRIMER CHUTE

PLEASE CHECK AVAILABILITY (upper right corner).
LIMITED SUPPLY-NO BACKORDERS.

ABSOLUTE TWO PER ORDER LIMIT
DUE TO PRODUCTION RATE

The TITAN PRIMER CHUTE is an PLA plastic "3D printed" part that fits snugly into the base of a Lee Pro 1000 or Value Turret Press. The chute funnels spent primers down to a spout where they drop through a 3/4" hole drilled through the bench top. The spout accepts a PVC Tube and Cap (sold separately) that holds the spent primers. With the Titan Primer Chute you will never need to unbolt the press to empty the spent primers again.

NOTE: This primer chute is for the Pro 1000 and Value Turret Press ONLY. It does not work with any other presses.

NOTE: If you choose to get a tube other than the PVC tube below be sure it is made of a rubbery material to stretch over the down spout. The inside diameter of the tube MUST BE 1/2".

Click Here for PVC Tube

Click Here for Tube Cap


NOTE: This Primer Chute does not fit the bases of Pre-1992 presses. If your base has strength ribs inside with an "X" pattern as shown below your press is Pre-1992. We do not make a Primer Chute for these early presses.


Write a review

Please login or register to review