Have a Question?

< All Topics

Tipped Primers

These Are Possible Causes Of Tipped Primers

"CLICK HERE" to view a picture of the ledge in the Load Master carrier that must be cleared of debris to allow the primer pin to drop down all the way.

Possible Cause Remedy
Case retainer out of adjustment See adjustment procedure in this manual
Cases not aligned well due to out of tolerance or damaged rim Install sizing die without decapper in priming station for better alignment.
Dirt or gun powder in shell holder grooves Scrape shell holder grooves with paper clip. Use compressed air to remove debris.
Tumbling media on primer post or in primer feed Remove and clean primer feed. Do not process cases with tumbling media lodged in primer flash hole
Table of Contents